Nokia 12 GSM MODULE REMOTE I/O Manual de usuario Pagina 33
- Pagina / 53
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Note: If an alias is defined, the default command will be disabled. There can be
only one effective command or alias for each function at a time. An alias must not
be equal to a default command.
Empty aliases cannot be used. If an empty alias is set, the default command will
remain effective.
Note: The alias string must be unique and the maximum length is 24 characters.
Neither commands nor aliases are case sensitive. However, the message identifier
and password are.
Table 5. List of response messages
Response Message Description
OUTPUT x: ON
Alias for output x on state, x = pin number 1-9
OUTPUT x: OFF
Alias for output x off state, x = pin number 1-9
INPUT x: *
Alias for input x voltage *, x = pin number 1-3
INPUT x: ON
Alias for input x on state, x = pin number 4-11
INPUT x: OFF
Alias for input x off state, x = pin number 4-11
* The value of the sampled voltage will be added to the end of the response. The value of the sampled voltage is
between 0 – 2800 mV, for example:
INPUT 1: 10mV
9.3 DETAILED COMMAND INFORMATION AND RESPONSES
All example commands in this chapter use the “term123” identifier string, and
the password property is set off in all of the subsequent chapters.
Note: If a command or the alias defined for it is not identified, but the identifier and
the optional password are correct, the Nokia 12 GSM Module will send an error
message as a response to the command originator, for example:
Control message: term123 passWORD ResetAll
Response: ERROR (Unknown Command)
9.3.1 Changing the Password
Use the Change_Pword command to control the password. Note that all
example commands in this chapter use the “term123” identifier string (see
Table 6).
29/49
- NOKIA 12 GSM MODULE 1
- Contents 2
- ACRONYMS AND TERMS 5
- 1. ABOUT THIS DOCUMENT 6
- 2. INTRODUCTION 7
- 3. SECURITY 9
- 4. GETTING STARTED 11
- 4.3 MANDATORY SETTINGS 12
- 5. OPTIONAL CONFIGURATIONS 17
- 5.2 SECURITY SETTINGS 19
- 5.2.1 Authorised numbers 19
- 5.3 ALIASING 21
- 5.4 INPUT SETTINGS 23
- 7. SUPPORTED CHARACTERS 29
- 8. COMMAND SYNTAX 30
- 9.1 COMMANDS 31
- 9.2 STATUS MESSAGES 32
- 9.3.1 Changing the Password 33
- 9.3.2 Reading Inputs 34
- 9.3.4 Reading Outputs 38
- 9.3.5 Writing Outputs 39
- 9.3.6 Inverting Outputs 41
- 9.3.7 Output Pulses 42
- 9.3.9 Location information 47
- 10. SAFETY INFORMATION 50
- 10.2 ANTENNA 51
- 10.3 MEDICAL DEVICES 51
- 10.4 VEHICLES 51
- 10.6 CARE AND MAINTENANCE 52
JVC HR-DVS2EU Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Videorecorder JVC HR-DVS2EU.
Wir stellen 1 PDF-Handbücher JVC HR-DVS2EU zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Comentarios a estos manuales